Paramount Networking Ltd

Alcatel-Lucent (Nokia) SR-OS – Port Encapsulation

Layer 2 Port Encapsulation

My first (hopefully of many) technical blogs.

OK, so port encapsulation may not sound like an exciting topic to write a piece on, but I have answered many questions on this and think it’s worth writing an article on.

The SR-OS is very different to the Cisco OSs due to the the fact you must configure a port ethernet encapsulation before you can tie any services to the port.

On Cisco, you set the encapsulation directly under the sub-interface a la:

interface GigabitEthernet0/0/0/0
 ipv4 address 10.0.0.20 255.255.255.0
!
interface GigabitEthernet0/0/0/0.1000
 encapsulation dot1q 1000
!
interface GigabitEthernet0/0/0/0.1001
 encapsulation dot1q 1000 second-dot1q 2000
!

So each sub-interface can be set to either dot1q or qinq.

 

But, on Alcatel-Lucent SR-OS products, the port encapsulation must first be configured before any SAPs (equivalent of sub-interfaces) can be created.  

There are three port modes on SR-OS that can be selected:

  • Null
  • dot1q
  • qinq

Null

Null mode refers simply to untagged packets.  This is similar to 

 

 

Leave a Reply

Close Menu